Guide

What It Does

Liquid Glass helps restore old, faded car paint by making your clear coat look 60–90% better. It adds deep shine and long-lasting protection in just one coat.

✅ Before You Start

Use only on the outside of your car
Apply when it’s cool (between 10°C–32°C or 50°F–90°F)
Avoid high humidity (under 90%)
Work in a well-ventilated area
Wear gloves and a mask
Keep your car dry for 24 hours after applying
Test on a small area before doing the full car

🧼 Step 1: Prep the Surface

Wash the area using water or detailing spray
Wipe with Wax & Grease Remover for best results
Optional: Use a clay bar for extra smoothness
Make sure the surface is completely dry
Practice on a small section first

🖐️ Step 2: Apply the Product

Shake the bottle well with the cap on
Remove the seal under the cap
Apply Liquid Glass to a folded cloth or applicator pad
Use enough to keep the cloth wet
Start from the top corner of the panel
Wipe in straight, even lines using light pressure
Slightly overlap each pass to cover the panel evenly
You have about 2–3 minutes to work with the product
If you miss a spot, fix it during this time
Do not go back over the same area after 3 minutes

Need to remove it?
If you make a mistake, remove the coating within 15 minutes using Wax & Grease Remover
Once it dries, it becomes harder to remove, but can still be reduced with repeated cleaning and effort

⏳ Step 3: Let It Cure

Let it dry untouched for 24 hours
Do not let water touch it during this time
After 48 hours, you can hand wash the vehicle
Avoid automatic car washes, as they can scratch the coating

🚫 Common Mistakes (And How to Avoid Them)

Streaks
Cause: Going over areas too much or applying randomly
Solution: Apply in straight lines with a wet towel

Rainbow spots or dull areas
Cause: Not enough product or uneven pressure
Solution: Use more product with light, even pressure

Bubbles or fish-eyes
Cause: Moisture or reapplying too soon
Solution: Let each coat dry fully for 24 hours

Dirt specs
Cause: Poor prep or dirty surface
Solution: Clean and dry the area thoroughly before applying